
RAFIX 22 FS+
FAST & SLIM
COMMON SYSTEM DATA
Front panel
Panel cut-out
The actuators featured in the RAFIX 22
FS+ series are suitable for 22.3 mm pan-
el cut-outs according to IEC 60947-5-1. All
actuators are equipped with a locating
pip. This locating pip ensures the perfect
fit of actuators and contact blocks for
PCB-mounted components and is there-
fore essential for a design built with
these contact blocks.
Grid spacing
The design principle makes it possible
to use a minimum grid spacing of
30 mm x 30 mm. In such an arrange -
ment, actuators with square collars can
be aligned directly without any gaps.
When designing the grid spacing, it is
recommended to consider any external
legending required (for example, using
labels strips inserted into the front
panel).
Assembly of the front actuators
Single-handed assembly method
For assembly, insert the actuator into the mounting hole from the front side. It is
clamped in the panel cutout. Subsequently you can screw on the actuator from the
rear using the ring nut. You can perform these steps one after the other with one
hand! Even better: you can start by inserting all actuators from the front side first and
subsequently fasten the threaded rings from the rear in one go. We recommend us-
ing the RAFIX fixing spanner to ensure proper tightening.
8